3 Month Anniversary – January 15th

famers

These are the framers – we are having a (almost) lock up party on Friday afternoon after installing the doors that arrived.  Jeff and his crew did a great job and were great to work with – I highly recommend them if you are looking for a framer.  They will be back to do the back-framing in 2 to 3 weeks.

windows

Three months to the day we started work on the foundation footings, we have all the windows in, the roof shingled, the mechanical work started (ducts) and the rough-in plumbing underway. We are about 3 weeks behind my original guesstimate as we had to wait 2 weeks for roof trusses and had about a week of weather delays (with more snow forecast for tonight.  The snow does slow down the work, e.g., the roofers had to shovel off the roof before putting down ice and water shield over the entire roof, and then shingles. The doors arrive tomorrow morning from Vancouver (weather permitting) although two of them will now not arrive until March! Got this news earlier this week. Not a show stopper, but does slow things down a bit again.

We are now busy deciding on plumbing fixtures, insulation, siding, flooring, etc etc.

windows

The windows are high-performance and we have put blue-skin membranes on the sides and a red membrane on the sill – these membranes close over nail holes and seal tight to the wall (when it warms up).

pipe

View of the heating/cooling ducts that will be under the floor in the living/dining/kitchen area. The ducts and joist sit on the slab (which is insulated underneath and isolated from the foundation walls). The sub-floor should go on in a few weeks after we run some electrical and pipes for the central vac.

pipe

This is the double wall chimney pipe for the wood stove that will go in the basement. The chimney will run through a closed chase through the guest bedroom and the upper floor – should be a great draft.

One thought on “3 Month Anniversary – January 15th

  1. 家らしくなって来ましたね。窓も入り暖房も付きましたね
    とても素敵なお宅になりましたね。私も楽しみに待っています。

Leave a Reply

Your email address will not be published. Required fields are marked *